Page 54 - TPM Issue9

Mountain Scale

Manufacturing

Accessories

In issue six of TPM magazine, I introduced a new model manufacturer, MSM (Mountain Scale Manufacturing),
a model producer based in Liechtenstein developing and producing 3d printed models of accessories which
make great diorama pieces or loads for vehicles. They have been busy over the last 12 months with a number
of new products which we now take a closer look at here. For full details of MSM’s range of models, check
out their online shop www.msm-modelle.com/shop or drop them an email to msm@hofiweb.li

Crane Mats
The crane support mats are available in five different
sizes ranging from 100t to 500t in 100t increments.
Each set consists of a grey coloured storage frame that
hold the four yellow-coloured mats which have red
squares in the centres and raised corner nubs to allow
them to stack neatly.

Left: Above:
The frames have holes Shown here are three sizes, all coming complete with grey
where chains can be coloured holder frame contrasting well with the yellow mats.
attached to show the
mats being lifted.

Above:
The mats themselves have small raised areas on
the corners to allow them to stack neatly.

Above:
The frames are the right width to
fit onto the beds of various trailers.
Shown here on the deck of a
Above: 4- axle Nooteboom trailer.
The mats work well with any size crane, as shown here
with the Link-Belt 100 R/T using the smallest 100t set.

54 TPMMW Magazine - Winter 2021